I've been messing with this finicky car for quite a while ...
currently the starter gear is locking up with the flywheel and have to loosen the starter mounting to get it free. the gear is worn with slight chipping and am looking to replace it to eliminate that...
I posted this on the Durant Face Book page, but wanted to give it as much exposure as I could. Thinking someone will be interested in purchase?
This is not my car - I saw it advertised on Facebook Marketplace and if I wasn't in the middle of several projects would p...
I have a beautiful and very unique project that I unfortunately don’t have the time for. It is a 1927 Durant M2, and according to the Durant Automobile Club of America, it is 1 of only 10 known in existence to this day. It is a full restoration project includin...
We have many parts left over from a 1925 Star parts car.
Frame
Engine (might be locked up)
Floor boards
Springs
Bumpers
Hood side panels
Exhaust
Windshield frame
Trans
Front Axle
Rear end
2 front doors
Passenger side rear door
4x4.50x4.75x21 Tires
Pa...
One 1928 Durant 4 cyl Sedan in need of restoration. $3000 Obo 98percent of the wood is there. All the wood inside is in really good shape. I have the roof lumber in my house. Send a note if interested for pictures.
1925 Star Parts for Sale
Motor
Starter
Front and Rear Axel
Steering Column
Steering Boxes
Wheels and Assorted Wheel Parts
Water Pump
Springs
Dash
Steering Wheel (no wood)
Hubcap
Misc. Small Parts
$200 OBO
Located in Long Beach, California
Judy373...
Hello Durantonians!
If anyone in their Durant travels knows of a Star CC chassis out there, let me know. I don't need a body, just from the cowl forward, motor, radiator and frame. As far as I can find the CC was the Star commercial chassis for truck bodies etc....
Hi:
I just got a call from an elderly gentleman in Boston. He told me that he bought and sold old buildings. The one he just bought had several real old Durant parts and he would like to get them to someone who could use them. This is what he said that he had:
an...
We have a 1927 Star roadster with a 14L 6 cylinder engine, We have a radiator which is leaking and plugged. We had it off once and was cleaned,( not Sure if this worked)
So we need a used replacement in better shape and not plugged, or where can we source a new mo...
Hi All,
As we are finishing Cathy's Star roadster, one of the last items needed is a Star tail light.
This is the oblong light used on the 26-27 Stars. It was also used on the Chevy "4's" of the same period.
We are hoping to bring this car to the Flint meet.
Any...
Hi, we have a 1924 Rugby Ute - continental 4 cylinder F Model and we are looking for some parts.
We need a transverse tube and brackets and a complete distributor.
Located in Australia
Thanks Tania
Durantonians- I've decided that it's time to sell my 1930 Durant 6-14 roadster. I'm just not using the car and it should have another caretaker. Call at 208-310-6300. Asking $30,000.00 for this restored beauty. They don't come up very often! Jim Colbert
Hi all! I have a W5 with a broken off distributor that I bought explicitly to try an construct a distributorless ignition for. Well challenge completed and my boss says it has to go. It will be going to the recycler very soon unless one of you would like the entire m...
1931 Durant 412 Tourister for sale. Appears to be mostly complete but totally disassembled. Wood is in rough shape and some is missing. Metal panels are in good condition with only surface rust. It was disassembled in the 70s by a previous owner and has been stored i...
I came across a 27 durant. This is a nice car however it is a little much for my knowledge of old car. It runs great and is a fun car its just way to much to much to up keeo for me. I have no idea what its worth just would like to sell before snow flies so i dont hav...
1928 Durant For Sale in Indiana. Beautiful inside and out. Always stored in a temperature controlled garage. The original engine and transmission have been replaced with a 1983 Ford 6 cylinder engine and transmission for reliability purposes. We still have the...
You just don't see these come up that often, if ever. Use tab from the menu at the left side of page and go to ebay Durant. Radiator cap in pretty decent shape for $60.00.Often lost or stolen from our cars. Ross
1928 (Durant era) Locomobile model 8-80 sedan for sale on BringATrailer. Car is located in the San Francisco Bay area. Mike Babick must know about this one. Looks nice, needs some recommissioning work. Offered by a dealer.
I have 2 hub cap wrenches for cars with larger hubcaps. These are larger than the 1930/31 hubcaps. (Maybe for Mike's Locomobile?)
The light colored wrench measures 3 and 1/2 inches across the open end. The other two wrench openings are 1 and 1/2 and 1 and 1/4 inch...
I wonder if anyone has one of the small handles for the seat adjuster on 1930 = 1932 Durants?
Will has just purchased a 1930 Durant Roadster and we need a handle for the seat adjuster.
Gord
Hi I am looking for distributor drive gears my housing is ok but the gears do not look like they belong. the distributor gear has been ground to fit and the generator gear is not centered in the housing.Generator number MC 4004 engine date 11/1922. I am thinking long...
This door handle has a shorter shaft than the sedan door handles, and has a stamped steel, flat baseplate unlike the curved cast baseplate on the sedan handles. It has the "spear point" design introduced in 1930.
I will bring this with me to the Durant meet in Gra...
Durant, Weston and Mott had extensive business dealings. This wrench is stamped "WESTON-MOTT CO". The large end will fit early Durant hubcaps. The other two wrench openings may fit anything. It also has two short pins on one side, but I do not know their purpose.
I...
One aluminum step plate which I believe is for a Star. It has a large Star in the middle of the step plate. There is one small crack in the left lower corner about an inch long. A good vintage driver quality step plate.
I will bring this with me to the meet in Grand...
A new set of 16 rubber universal joint balls. I previously bought these thinking they were needed for my 1930 Durant. They are for earlier model cars, not 1930.I will bring these with me to the Durant Meet in Grand Junction next week.
1923 Durant Star touring automobile
Needs complete restoration and has serious rust issues with that said everything is here motor with all parts are in decent shape frame is complete. Car was parked by family after a loss in family and sat under a tree and melted....
1923 Durant Star touring automobile
Needs complete restoration and has serious rust issues with that said everything is here motor with all parts are in decent shape frame is complete. Car was parked by family after a loss in family and sat under a tree and melted....
Several years ago, back in the Jeff Gillis days, John Baraldi was manufacturing new Rocker Arms for the A22 Durant motors. Does anyone have a set that they would like to part with, or have any information on them. We have broken one of the original ones on our 1922 E...
I have a garage full of parts - What do you need?
7 hoods,5 transmissions, 3 sets of springs, 4 ring gears, 2 1/2 motors, 2 rear ends, front assembly, 4 radiators w/cowl, many brake drums and parts, manifolds, pumps, crankshafts, heads, shocks, spokes, electrical pa...
I'm looking for parts to a 15U motor (1928-1930)
needing a:
Generator (chain driven) Auto-Lite # GAL 4104
Distributor Auto-Lite # IGB 4008B
520 818 3391 flintauto@gmail.com
1963 AACA National First Prize winner 1925 Star Touring car. A very solid and good running car that still presents well. Has steel disc wheels, all gauges & lights work except speedo. Steel body and fenders, good tires and tubes. Comes with a very nice comfy brown le...
In case anyone missed this--Lance Hayes in San Diego wants to get rid of his Durant parts for free or cheap. His health is declining and he wants to help out where he can. His notice is posted in the "test only" section on the forum menu and it may not have been noti...
Years ago, may have been in the Jeff Gillis days, someone reproduced the Star sign which said, " Low cost Transportation, Star Cars, Authorized Service, Durant Motors". Does anyone know where I can get one of these signs, or if anyone is still making them Regards, Curt
My car has the Chevy style oval tail light. I have several plugs with the protruding spring loaded pins but they all protrude too far to engage the pins that lock the plug into the socket. I need the plug and I'm missing the license plate light lens. Any one know whe...
Saw this 23 Dort on Craigslist. It is located in Bakersfield CA. I saw the car at a pawn shop in Bakersfield about 5 years ago. The description says engine runs well but the upper radiator hose is missing (exactly the same as it was 5 years ago). If anyone is interes...
Looking for a 19 inch, 6 lug wire wheel, 6 1/2 inch center for a 1930 6-17 Durant, should be the same as for 6-14
Bob Smith 520 818 3391 flintauto@gmail.com
I am looking for a motometer for my 1928 Durant M-2. I have seen them advertised on Restoration Supply but I was interested if someone reading this post might have one to sell.
There is a sedan on BringATrailer with a Hayes built body like some of our cars. A 1929 Marmon model 78 with a straight 8. Some similarities in styling with our cars (although a lot of cars from the era where close in looks). Photo #107 shows a Hayes body tag from th...
I have a surplus instrument panel for 1930 Durant car models 407, 611, 612, 614, 617 and it also fits 1930-33 Rugby trucks 406, 416, 615, 616. It's in average shape, quite restorable and has the chrome trim piece still attached on the front. Only the speedometer is a...