Thanks Rick. I would still like to hear from anyone who has some experience using the tool. Any tips from anyone?

I'll add some tips not in the instructions, listen to the sound of the cutting element, whether it is wire or filament. It will "tune up" like a guitar string when under load. Learning the sound will prevent breakage.

In tough corners, tension the CE then stop and pull the CE by hand to feel the adhesive, as it slackens under pressure, retention and repeat until you get through the hard section.

If the Anchor / Pulley Cup or APEX are moving under tension, re-position them and or the Bot to reduce angles / forces.

If I get any responses on the FB pages I'll share them here as well.

Rick

Thanks!