AGRR™ magazine/glassBYTEs.com™ Message Forum

AGRR Magazine
AGRR™ Magazine

glassBYTEs.com

AGRSS

NWRA

Key Media & Research
Privacy Policy


ATTENTIONThe glassBYTEs.com forum is being retooled and will return with a new look and functionality that will hopefully help our readers even more. Watch for an announcement when it will be ready, it will be a few months.

You can still stay up on daily news and comment on stories by signing up for the glassBYTEs daily e-newsletter at glass.com/subcenter. There is no charge. Hope to see you there!
General Forum
This Forum is Locked
Author
Comment
View Entire Thread
Re: Glassbot

I'll add some tips not in the instructions, listen to the sound of the cutting element, whether it is wire or filament. It will "tune up" like a guitar string when under load. Learning the sound will prevent breakage.

In tough corners, tension the CE then stop and pull the CE by hand to feel the adhesive, as it slackens under pressure, retention and repeat until you get through the hard section.

If the Anchor / Pulley Cup or APEX are moving under tension, re-position them and or the Bot to reduce angles / forces.

If I get any responses on the FB pages I'll share them here as well.

Rick

Re: Glassbot

Thanks!

Copyright © AGRR™/glassBYTEs™ All rights reserved.
20 PGA Drive, Suite 201, Stafford, Virginia 22554
540-720-5584 (P) 540-720-5687 (F) info@agrrmag.com
www.agrrmag.com / www.glassbytes.com