ATTENTION: The glassBYTEs.com forum is being retooled and will return with a new look and functionality that will hopefully help our readers even more. Watch for an announcement when it will be ready, it will be a few months.
You can still stay up on daily news and comment on stories by signing up for the glassBYTEs daily e-newsletter at glass.com/subcenter. There is no charge. Hope to see you there!
SLK has the same basic side moldings that are on with clips you need to remove the side moldings from the top of the sides as the lower corners slide on to a plastic connector that holds it to the top of the fender no screws on the side moldings once the sides are off there is a cable that attaches to the top clip and loops thru a hole on the molding ( the only use I can gather this cable is for is it the molding pops off it will not hit the vehicle behind you ???)these cables will slide off the molding so you can get them out of the way, the top molding pops right up but be careful as it is flimsy and when reinstalled may not fit flush against the glass these cut out fine on the top and 2 sides the bottom can be cut with a long knife use care not to damage the rubber that wraps around the windshield you will need to reuse it as it cushions the glass against the u shaped cowl the w/shield sits in. The wiper arms remove easy unlike some benz, the nuts are 13mm or 14mm! To install the only tricky part is the lower rubber I tape it to the glass set the w/shield and then remove the tape! 1 of the simplist benz to do! Hope this help !