- A Bravenet.com Forum

ATTENTION: The glassBYTEs.com forum is being retooled and will return with a new look and functionality that will hopefully help our readers even more. Watch for an announcement when it will be ready, it will be a few months.

You can still stay up on daily news and comment on stories by signing up for the glassBYTEs daily e-newsletter at glass.com/subcenter. There is no charge. Hope to see you there!

Recent Posts

General Forum

This Forum is Locked

Author

Comment

Dec 30, 2005 - 4:25PM

corvette

Has anyone taken the sunvisors loose on a 2005 or 2006 corvette.

Syd

Dec 30, 2005 - 7:09PM

Re: corvette

Sorry, no help here, but doesn't that just SOUND horrible??? Yikes!!

mojo7

Dec 30, 2005 - 9:18PM

Re: corvette

have done a couple ws's never had reason to remove sun visor. how come you need to remove it?

Dec 31, 2005 - 9:29AM

Re: corvette

Need to pull inside top trim to take off roof seal.
Might work around it but thought it would be safer when cutting out top of glass.

mojo7

Dec 31, 2005 - 6:34PM

Re: corvette

roof seal in like side seal wedges in channel. if you're careful all you need to do is pull the front (ws side) of moulding out of lip, and it will give you room to cold knike top. rubber is like old vet, but no adhesive used. Easier to do then older vettes.

Jan 2, 2006 - 5:51PM

Re: corvette

We finally removed the sun visors-there is a notch in the plastic disk that visor arm goes through. Place the end of a small flat blade screwdriver in the notch and turn the visor arm against the screwdriver and the visor base rotates and comes out. There was a box (part of GPS almost against the top of car and we were afraid of damaging or cutting a wire). Thanks for responses.

Free Forum powered by Bravenet