Looking for a supplier of the Cam Followers, adjusting screw & lock nut from Continental engine They are 3/8 national fine thread New or NOS or even good condition second hand. The spanner facings need to be in good order.
Progress on Engine rebuild: Con rods straightened and shot peened, Pistons dispatched from JP Pistons Adelaide. No. 3 cylinder new liner and crankshaft polished. Bearings mains & big ends to be poured this week. Hopefully once line bored reassembly next week.

Do You own a car built by Durant? 1929 D-66

Phil If your cam followers are the same as the W5 engine i have spare ones allso new springs.Ring me with measurements.May be going to motorfest in Cooma could bring them along Regards Brian

Hi Phill. I have dozens 2nd hand.
Sid

Do You own a car built by Durant? yes