- A Bravenet.com Forum

ATTENTION: The glassBYTEs.com forum is being retooled and will return with a new look and functionality that will hopefully help our readers even more. Watch for an announcement when it will be ready, it will be a few months.

You can still stay up on daily news and comment on stories by signing up for the glassBYTEs daily e-newsletter at glass.com/subcenter. There is no charge. Hope to see you there!

Recent Posts

General Forum

This Forum is Locked

Author

Comment

wsm glass

Nov 2, 2011 - 8:48AM

2011 infiniti qx56

IS ANYONE FAMILIAR WITH REMOVAL OF THE EXTERIOR SIDE PILLAR MOULDINGS AND TOP MOULDING? ARE ANT NEW CLIPS NEEDED?

bhaus

Nov 2, 2011 - 9:07AM

Re: 2011 infiniti qx56

Just replaced one, two end moldings with clips
with torx underneath sides pop off top molding
has to be replaced but easy Had to get mine from
dealer. Side moldings pop up after the screws are off

wsm glass

Nov 2, 2011 - 9:17AM

Re: 2011 infiniti qx56

OK. THANKS FOR RESPONSE. TOP MOLDING CANNOT BE REUSED MUST ORDER NEW?

Shop Guy

Nov 2, 2011 - 1:10PM

Re: 2011 infiniti qx56

That's correct, I have not even come close to being able to save the top molding on one of these.

wsm glass

Nov 2, 2011 - 5:29PM

Re: 2011 infiniti qx56

thanks for that SHOP GUY. just ordered one and its not cheap, naturally.

DMG56

Aug 31, 2012 - 3:47PM

Re: 2011 infiniti qx56

We were able to save the top moulding by using the same tool as you use on the side mouldings for the Dw 1551 (Ford trk). There are a lot of clips across the top(10+). These clips go into a top retainer. Take your time and its not too bad.

Larry

Mar 26, 2014 - 7:17PM

Re: 2011 infiniti qx56

what tool is that I always use a fiber stick.

markk

Mar 26, 2014 - 9:18PM

Re: 2011 infiniti qx56

equalizer tool part num. ftf399

Free Forum powered by Bravenet