AGRR™ magazine/glassBYTEs.com™ Message Forum

AGRR Magazine
AGRR™ Magazine

glassBYTEs.com

AGRSS

NWRA

Key Media & Research
Privacy Policy


ATTENTIONThe glassBYTEs.com forum is being retooled and will return with a new look and functionality that will hopefully help our readers even more. Watch for an announcement when it will be ready, it will be a few months.

You can still stay up on daily news and comment on stories by signing up for the glassBYTEs daily e-newsletter at glass.com/subcenter. There is no charge. Hope to see you there!
General Forum
This Forum is Locked
Author
Comment
LEE bent glass

hello sire
i sent you an e-mail but got no response.
maybe it looked like junk mail or something. i can make a pattern out of 1/8 steele, and ship it to you if you think you can make me a back glass. lami is ok it doesnt need to be temp ill be carefull.

Re: LEE bent glass

I tried to e-mail you but it came back. E-mail me again and I will try to send you some pics to show you what we need to do this. We use 1/8" x 1" mild steel strap for the perimeter and 1 1/2" x 1 1/2" x 3/16" angle for the base. Also the outside perimeter of the tool needs to be the size of the piece you need. Sometimes this is not so easy to do but the closer the better.

Re: LEE bent glass

*** ATTENTION ***

Your e-mail is being returned to you because there was a problem with its
delivery. The address which was undeliverable is listed in the section
labeled: "----- The following addresses had permanent fatal errors -----".

Hard to e-mail you when it comes back.

Re: LEE bent glass

maybe this one will work

Copyright © AGRR™/glassBYTEs™ All rights reserved.
20 PGA Drive, Suite 201, Stafford, Virginia 22554
540-720-5584 (P) 540-720-5687 (F) info@agrrmag.com
www.agrrmag.com / www.glassbytes.com