AGRR™ magazine/™ Message Forum

AGRR Magazine
AGRR™ Magazine



Key Media & Research
Privacy Policy

ATTENTIONThe forum is being retooled and will return with a new look and functionality that will hopefully help our readers even more. Watch for an announcement when it will be ready, it will be a few months.

You can still stay up on daily news and comment on stories by signing up for the glassBYTEs daily e-newsletter at There is no charge. Hope to see you there!
General Forum
This Forum is Locked

Any tips on this install would be helpfull

Re: fw317

no they are easy

Re: fw317

Side drip mld's have 3 screws under rubber flap and 1 at top. W/s mlds are held on with friction clips use dr panel tool to pop off. Early ones had rock hard urethane that separated from glass and usually peel off body after glass is out. Newer ones were butyl set. No need to pull bottom side cowls. Use thin set blocks on top of bottom clips. HTH

Re: fw317

there is a round cloth covered trim on the inside of the dash close to the adhesive, be careful or you will tear. People who own these cars tend to be a bit anal about this.

Copyright © AGRR™/glassBYTEs™ All rights reserved.
20 PGA Drive, Suite 201, Stafford, Virginia 22554
540-720-5584 (P) 540-720-5687 (F) /