- A Bravenet.com Forum

ATTENTION: The glassBYTEs.com forum is being retooled and will return with a new look and functionality that will hopefully help our readers even more. Watch for an announcement when it will be ready, it will be a few months.

You can still stay up on daily news and comment on stories by signing up for the glassBYTEs daily e-newsletter at glass.com/subcenter. There is no charge. Hope to see you there!

Recent Posts

General Forum

This Forum is Locked

Author

Comment

Lee

Jul 21, 2006 - 8:29PM

SOLSTICE/CAMARO

Just did one. Cold knife all around 1 1/4" blade. Sealant is in 1/2" around top and sides. Only problem was molding on new glass at upper corners. Mld pulling away needs to be serrated to bend correctly.
Also did an R&I on a new Camaro prototype. Glass slid down total urethane failure. They had paint for a frit the thane didn't stick to it. Hope the production car is better built than this one. These cars are being used for the movie Transformers. This is going to be one heck of a car movie.

Free Forum powered by Bravenet