AGRR™ magazine/glassBYTEs.com™ Message Forum

AGRR Magazine
AGRR™ Magazine

glassBYTEs.com

AGRSS

NWRA

Key Media & Research
Privacy Policy


ATTENTIONThe glassBYTEs.com forum is being retooled and will return with a new look and functionality that will hopefully help our readers even more. Watch for an announcement when it will be ready, it will be a few months.

You can still stay up on daily news and comment on stories by signing up for the glassBYTEs daily e-newsletter at glass.com/subcenter. There is no charge. Hope to see you there!
General Forum
This Forum is Locked
Author
Comment
03 Mustang--info needed

Hi,

We are replacing a quarter glass on '03 Mustang.

Info needed for removing the quarter body panel. How do you get to the clips under the body panel?

Thanks, Western Wishes

Re: 03 Mustang--info needed

Upper roof panel is attached from inside with 7/16-11mm nuts. Easy replacement. Pull interior and remove panel and whats left of the glass.

Re: Re: 03 Mustang--info needed

look good for bottom nuts in far back bottom.After all nuts removed carefully pull from outside top joint(about center top of door)downward, has a cip .

Re: 03 Mustang--info needed

They got part of it right.But if im not mistaken,you will need to remove the door weather strip,the torx that hold the weatherstrip goes into.And then remove 2 of the phillips screws towards the back.This is so you can remove the clip that holds the quarter panel trim.Just my opinion.

Re: 03 Mustang--info needed

Thanks Lee, Ryan, and SmartGlass for your help!
Much appreciated! ~Western Wishes~

Copyright © AGRR™/glassBYTEs™ All rights reserved.
20 PGA Drive, Suite 201, Stafford, Virginia 22554
540-720-5584 (P) 540-720-5687 (F) info@agrrmag.com
www.agrrmag.com / www.glassbytes.com