Frank, I purchased a Zenith 13922 a few months back, but have been not been up to doing anything until the arrival of my sons for the holiday. They insisted that we install this puppy and make something happen. To our surprise, however, the bolt spacing is off by a full quarter inch, 2 3/8 on the Zenith, 2 5/8 on the Durant. Is there any fix for that, or do I have to continue searching for a different carb?
Thanks,
I found the same thing. I just used smaller diameter bolts with a washer on top and bottom.
This will pull the carb up tight and the carb outlet will match the intake manifold.
Where Are You From? Kamloops BC Canada
Do You own a car built by Durant? 1926 Star (being restored to a delivery service van)