Durant Motors Internet Forum

Our Purpose

  Preserve the automobiles manufactured by the Durant Motor Company, provide enjoyment for each member with meets, tours & technical assistance.


This forum is provided by the Durant Motors Automobile Club located at durantmotors.org

How to Add Pictures             Rocky

General Discussion Forum
Start a New Topic 
Author
Comment
View Entire Thread
Re: license plate frame

Hi Marty.

If you go to the Early Bird swap meet in Puyallup at the Fairgrounds, you will probably be able to find a long, narrow frame to fit your license plate. I have seen them offered by vendors there. The swap meet is February 18 and 19 this year. It is a good meet, one I attend every year.

If you do not find a frame there, then try the Portland, Oregon swap meet April 7, 8 and 9. You will definitely find one there as it is the biggest swap meet in the northwest.

Maybe we will see each other at one of the meets.

Bob

Where Are You From? Ellensburg, WA

Do You own a car built by Durant? Yes

Re: license plate frame

Hi Marty,

Marty, I am a little confused, you mentioned having to "wire" your '28 WA license plate on the spare tire, Are you missing the original slotted bracket either inside the spair tire mount (wood wheels)or on a left hand curved tail light stand (wire wheel mount)? I have washington year of manufacture plates on all my cars and don't recall a mounting problem...(is their not enough room for the plate to fit inside your demountable spare rim?, also where will you install the license plate frame?) What part of Washington are you from.
Thanks, Bill

wash license plate photo IMG_0624_zpscm2acsot.jpg

Where Are You From? Leavenworth, WA / Yuma, AZ

Do You own a car built by Durant? '25 Flint H-40 2door / '25 B-40 Touring / '29 D-40 Coupe / '23 A-22 Touring

Re: license plate frame

hi:
Thank you for the response. i do have the wood spoke wheels and on the spare on rear of the car there is a bar about 3 inches wide across the spare so actually have it wired onto that but the bolt holes in it do not match. i am sure i could fabricate some kind of adapter but even then the plate seems like it is missing something to me. The plate i have is not actually perfect as some i have seen but not in bad shape for a plate of that age. The car is located in my garage at our winter home in Kennewick, Wa. We have a second home we bought about 5 years ago for retirement which I have been adding onto this summer. That house is located on Pueget Island in cathlamet , Wa. We are retired now but do not have a garage at the island house yet. Too many projects!!!!! I need to restore my Durant but have done very little so far since we bought the island house about 4 months after I bought the Durant. hope to finish the room addition on that house this next summer. Do not feel like working on the car in the garage here when it is 5 degrees above 0. Getting soft in my old age.

happy new year Marty

Where Are You From? Washington state

Do You own a car built by Durant? 1928 Durant M2

Re: license plate frame

Yes, you are welcome......Our son is keeping the home fires burning at our summer home northwest of Leavenworth, it looks like it will be cold with a lot of snow much of this week up there...It is surly nice to be down here in the AZ dessert this time of year.

Ya'll have happy new year.

Where Are You From? Leavenworth, WA / Yuma, AZ

Do You own a car built by Durant? '25 Flint H-40 2door / '25 B-40 Touring / '29 D-40 Coupe / '23 A-22 Touring

 

The Durant Motors Automobile Club