For the past little bit we have been replacing the gaskets on the engine chain case oil pan etc. I have the oil pan off at the moment, and am trying to figure out how the tube that the oil level gauge (on the side of the engine) comes off. It's pretty solid on there, I can't tell if it unscrews, or if there is another way to take it off. Does anyone know?
This picture is a little rotated, but you can see the tube on the right.
Where Are You From? Langley BC
Do You own a car built by Durant? Yes: 1928 Durant M2
It's just pressed in. Tap it sideways a little to loosen it and pull up.
Gerald Feather
Hello all.
For the past little bit we have been replacing the gaskets on the engine chain case oil pan etc. I have the oil pan off at the moment, and am trying to figure out how the tube that the oil level gauge (on the side of the engine) comes off. It's pretty solid on there, I can't tell if it unscrews, or if there is another way to take it off. Does anyone know?
This picture is a little rotated, but you can see the tube on the right.