Would anyone know what the valve clearance should be fo a Continental 14L engine? Are they to be adjusted hot or cold? Is the clearance for the intake valves the same as for the exhaust valves?

Also, what should the head bolts be torqued to?

Kind regards and thank you for the help!

Where Are You From? Iroquois Ontario

Do You own a car built by Durant? Yes, a 1928 D-60 sedan

Hi Claude.....

Most of the information you are looking for can be found on our Technical page.

Look at the Model 60 specs and tune up specifications....

Frank ---

Where Are You From? Hookstown Pennsylvania

Do You own a car built by Durant? a few

Hi Frank,

Thank you for your answer. Where do I find the Technical page? Is it on a different website? I've been trying all over to find a lead or a tab to it, but can't find. I didn't know that there was one, but I sure could use any information I could find there.

Thanks,

Claude

Where Are You From? Iroquois Ontario

Do You own a car built by Durant? Yes, a 1928 D-60 sedan

Claude,

Go to http://www.durantmotors.org


From there you will see yellow buttons or tabs on the left hand side, one of them will say Technical Page.

Rick

Do You own a car built by Durant? 1929 Model 60 Sport Roadster

Thanks Rick,

It worked and I found all kinds of interesting useful information there.

CHEERS!

Claude

Where Are You From? Iroquois Ontario

Do You own a car built by Durant? Yes, a 1928 D-60 sedan