ATTENTION: The glassBYTEs.com forum is being retooled and will return with a new look and functionality that will hopefully help our readers even more. Watch for an announcement when it will be ready, it will be a few months.
You can still stay up on daily news and comment on stories by signing up for the glassBYTEs daily e-newsletter at glass.com/subcenter. There is no charge. Hope to see you there!
You can still stay up on daily news and comment on stories by signing up for the glassBYTEs daily e-newsletter at glass.com/subcenter. There is no charge. Hope to see you there!
This Forum is Locked
Comment
do this today,anything to look out for on this job.
will be using ppg/glass on it. thank's
These aren't very hard at all. Pretty basic design unlike some of the former Pontiac models. Two 10mm screws hold the glass to the regulator. Door panel has two large phillips heads in the middle of the door panel and of course clips on the outter edges.
You shouldn't be there too long.
thank's for the tips AGN. job was very easy. ati-glass
fits perfect. 
Copyright ©
AGRR™/glassBYTEs™ All rights reserved.
20 PGA Drive, Suite 201, Stafford, Virginia 22554
540-720-5584 (P) 540-720-5687 (F) info@agrrmag.com
www.agrrmag.com / www.glassbytes.com